Essentially 2 fantastic amps in one.

The AER Domino acoustic guitar amp is the answer to demands for more. Musicians get more power, more volume, and more channels for bigger venues with the Domino combo. AER designed the amp specifically so an instrument's sound can be reproduced to perfection through a speaker/amplifier configuration. Of course, building an acoustic system and tuning it to match all registers required some innovation.

The Domino guitar amplifier consists of 2compact drivers: two 8 -twincone speakers, two 60 watts amps and four channels (Ch3 and 4 use a combined EQ).

The AER 32 bit effects-processor - 16 presets addressable by each channel by individual effect-sends - delivers a variety of very suitable effects for vocals and instruments.

Left and right out in combination with the pre-master out allow direct use of additional active speaker systems (AS281, Q8) to extend the Domino amp to a small club PA.

Based on the Compact/Bingo acoustic system AER has developed the Domino amp, a 100-watt amplification system, that combines the excellent tone of the Compact with increased power and higher efficiency.

AER Domino 2x60W 2x8 Acoustic Guitar Combo Amp Features:

• Channel one:
• Input(1): socket for a 6.3 mm jack plug, high impedance piezo input
• Channel mute: switch to mute the channel
• High/low: switch to adjust input sensitivity, high for high input sensitivity, low For low input sensitivity
• Clip: overload indicator
• Gain: input level control
• Color: mid-range contour filter
• Bass: bass tone control
• middle: middle tone control
• Treble: treble tone control
• Send: effect send control, adjusts the channels effect amount
  
  Channel two:
• Input(2): Combi-Connector with a socket for a 6.3 mm jack plug and XLR male socket
• Channel Mute: switch to mute the channel
• Line/mic: switch to adjust input sensitivity. Line: sources with line level, Instruments with active preamplifiers and magnetic sound pick-ups, connected To jack input only. mic: balanced microphone input with 48V phantom power to Be used with XLR and jack input, 48V for XLR only
• Clip: overload indicator
• Gain: input level control
• Color: mid-range contour filter
• Bass: bass tone control
• middle: middle tone control
• Treble: treble tone control
• Send: effect send control, adjusts the channels effect amount
  
  Channels three & four:
• Input(3): Combi-Connector with a socket for a 6.3 mm jack plug and XLR male socket
• Channel: Mute switch to mute the channel
• Line/mic: switch to adjust input sensitivity. line: sources with line level, Instruments with active preamplifiers and magnetic sound pick-ups, Connnected to jack input only. mic: balanced microphone input with 48V Phantom power to be used with XLR and jack input, 48V for XLR only
• Gain input level control
  
  Input(4): socket for a 6.3 mm jack plug, high impedance line/piezo input
• Channel mute: switch to mute the channel
• High/low: switch to adjust input sensitivity, highfor high input sensitivity, low for low input sensitivity
• Clip: overload indicator
• Gain: input level control
• Color: mid-range contour filter
• Bass: bass tone control
• Middle: middle tone control
• Treble: treble tone control
• Send: effect send control, adjusts the channels effect amount for both Channels
• 48V: 48 volt phantom power on/off
• Stereo sim.: stereo simulation on/off
  
  Effect/aux/master:
• Effect select: switch to select between 16 different effect presets 10 reverbs, 4 delay, 2 chorus
• Return: effect-return-control, sets the total level of the internal effect
• Aux return: aux-return-control, sets the level of signals connected to aux-in
• Effect 2 return: effect-return-control, sets the level of signals connected to return
• Pre master: level control for L-out, R-out and rec-out
• Power: power indicator lamp
• Master: overall volume level control

Watch your amplification difficulties fall away one by one... order the Domino today.